Pulse (signal processing)

From Wikipedia, the free encyclopedia

In signal processing, the term pulse has the following meanings:

1. A rapid, transient change in the amplitude of a signal from a baseline value to a higher or lower value, followed by a rapid return to the baseline value.
2. A rapid change in some characteristic of a signal, e.g., phase or frequency, from a baseline value to a higher or lower value, followed by a rapid return to the baseline value.^[1]

Frequently pulsing also refers to marketing strategy where marketing managers hope for carry over effects and pursue an on-again and off-again marketing strategy.

Contents 1 Pulse shapes 1.1 Rectangular pulse 1.2 Nyquist pulse 1.3 Gaussian pulse 1.4 Sinc pulse 2 References

[edit] Pulse shapes

Pulse shapes can arise out of a process called pulse-shaping. Optimum pulse shape depends on the application.

[edit] Rectangular pulse

These can be found in pulse waves, square waves, boxcar functions, and rectangular functions. In digital signals the up and down transitions between high and low levels are called the rising edge and the falling edge. In digital systems the detection of these sides or action taken in response is termed edge-triggered, rising or falling depending on which side of rectangular pulse. A digital timing diagram is an example of a well-ordered collection of rectangular pulses.

[edit] Nyquist pulse

[edit] Gaussian pulse

[edit] Sinc pulse

[edit] References

1. ^  This article incorporates public domain material from the General Services Administration document "Federal Standard 1037C" (in support of MIL-STD-188).